View Full Version : Mechanic's Corner
- oil tube
- speedo is off (but in the wrong way)
- noise
- jeep sputters
- s-10 transfer case
- number of splines?
- TJ Owners, be careful!
- Need Help With Grand Cherokee 4.0
- need help
- york compressor question
- AC Squeelin' - 98XJ
- not starting
- What is the difference?
- horrible, loud screeching noise from motor
- Big thanks to Ron
- air compressor advice
- Wet Weather Problems
- JEEP POWER STEERING
- I'm up!
- Chevy 250ci I6
- rice + mud
- Fuel Filter
- Water in Oil question
- battery charger
- Fuel Pump/Metal Shavings
- OBA working
- Dodge drive shaft
- 82 CJ7 Starting problem
- 86 jeep cheroke
- s-10 suspension lift
- toyota update
- vent leak
- 350 blocks
- Oil Leak
- Jeep Cherokee Mod
- Setting the Time
- carb problem?
- Cooling
- s10 towing a car
- toyota update
- rubber for fender flares
- Oil/Oil filters
- Looking at a CJ....advice needed
- HOT TANK
- Jeep Recall
- tuning
- Body lift
- Transmission Issue!
- Jeep Wiring,..need help.
- Transmission Problems
- frame painting
- hottanking a block, new freeze plugs and bearings...
- block question
- Big thanks to Skratch
- trans lines to coller and trans temp gage
- New LIFT: First impressions
- CB range
- Axle Wrap?
- CJ5 body swap
- Doubled Frame?
- Wheres the Dodge Specific Tech Page?
- On Board Air
- Heim Joints
- Shocks
- modifying axles
- Ford to Jeep rims
- Electrical sound
- rebuilding tranny, forgetting anything?
- My tranny help
- Engine Rebuild
- Found a good parts store in westerville
- Need some Quadrajet & fuel pressure advice......
- transmission/transfer case question.
- Scrap Metal?
- Custom Cages?
- My X needs a new clutch
- Rear drum to disc swap
- Install Rear Leaf Springs?
- roof scoop/snorkle/breather
- 2000 Cherokee rear axle question
- Tranny help
- Chevy Truck Gas Tank Dimensions
- T-4
- wanting to change auto to manual shift
- Broken Bolt
- Great Service
- Steering box
- FAN CLUTCH
- Retun Fuel Line
- another install complete
- any knowlege on auto trans to manual swap?
- Oil Pressure
- Alternator shops in Columbus area
- Lost My Dome Light, gauges, and radio.
- My New Toy
- Front Rubbing Noise 96 XJ
- Welding help
- SYE INSTALL
- Diff setup - good Columbus-area shop?
- chevy hybrid body swap
- 700R4 or TH400?
- Trailer Question...
- S-10 Solid Axle Swap
- SOA - need an "expert/professional"
- Pitman arm puller?
- Need a wiring expert
- 1994 Jeep Cherokee 4.0L auto transmission
- ABS/Brake Light....
- Where to have ARB installed
- Chevy 4x4
- custom bolts in Columbus?
- Shocking questions!!!
- Dana 60 carrier removal
- HiLift Maintenance
- Polyurethane bushings
- Rear 60 options
- Type F Trans Fluid
- NP231
- question about a Ford F-150
- engine codes
- Tire Repair: Best Option For New 42 TSL: Patch, Boot, Tube
- Columbus OH shop review
- New to Dayton Ohio and need a good 4x4 shop
- Land Rover woes
- Hole in my transmission
- Shock mount questions....
- Radiator Question
- PLEASE HELP I NEED ALL CAN GET............
- NP 205 seal size 1310 1330 1350 1410
- looking for a web addr.
- BB's and Golf Balls....
- Gear Ratio Calculator
- Water proofing
- Bronco AOD trans question from 73Mudslinger
- Axle Wrap
- Got Some New Toys! :)
- Changing Transmission on my cherokee
- welding
- possibly building a truggy need ideas
- Convert your axles to Portals
- Michelin Tweel
- Recovery strap
- 3-speed TCase
- Winch Dead (edit: Fixed)
- Alignments
- need welding help 2 projects
- Front Wheel bearing race?
- Air Compressor Options???
- Transmission Jack
- Stroker 4.0 to 4.7
- I need somebody to....
- Thunk in the floorboard.
- heavy duty shock mounts
- Valve Chatter...
- Aussie Locker ?
- Aussie locker install
- Front Driveshaft clearance from transmission
- looking for someone/somewhere to have R&P work done
- Transfer case question
- OBA??
- Cooling system advice
- NP231?
- Spicer U Joints
- ECM replacement 2001 Jimmy 4WD
- crank bearings!
- 2001 Jimmy 4wd stalling, reving
- Anybody in Columbus have a torch?
- Advice on Wheel spacers for front
- Loud noise from the rear....
- proportioning valve
- Locked Up Engine
- Best place to buy some DOM tubing in Columbus?
- Np-231 SYE
- HP60 Lower Kingpin Removal Problems..
- Brakes/Test Drive/Rob Strikes out with Eye Candy
- Enough is enough...
- dana 60 housing ends
- How many inches do I need around my shaft?
- Oil Pressure
- Welding helmet??
- Replacing D30 Pinion Bearings
- Cam failure or lifter failure or installer failure?
- fuel injection
- Machine shop in Columbus?
- Dana 30 carrier ?
- Buick Shop Manual?
- Exhaust work on '98 4.0L TJ
- Death to Hacks!!!!
- Street Tires?
- Driveshaft place in Columbus?
- Grooved tires
- crawl ratios...whatcha got?
- How to save a gel cell optima battery
- shims
- Pay close attention to new parts when assembling an engine.
- Rebuilding a Ford C6 Transmission
- Air compressor
- Valve Guides
- HELP, is it a D70!!
- Tranny Jack
- Trailer Questions...
- Towing 9,000 pounds with a ZF 5 Speed
- Engine is running too cold...
- Sonnax
- Changing a truck cab: How much of a PITA?
- Bad Ground???
- Ha! my backup lights finally work after 2 years!
- sway bar disconnects?
- Dana 28 axle
- Chevy windshield replacement
- Replacing the key switch in a Ford
- Welder?
- Torsion Bars
- EGR valve cause lack of power??
- funny oil leak.
- Atlas Leaking
- Increased my MPG 50% :mrgreen:
- stupid tire valve question
- Stupid wheel seal question
- Header install
- we have locker!
- trailer brake wiring?
- Eightball Award
- Decent & inexpensive body shop in Columbus area?
- TC inputs
- Novice Ride
- No Ignition Key
- Winch experts needed...
- sandblasting...media blasting
- HUMVEE Beadlocks
- Dodge RAM/15x10 8-6.5
- Take care of your trailer
- AC Manufacture?
- I found my noise
- Front drive shaft question
- antiwrap
- A/C on the Trail????
- onboard welder thoughts
- 30/9.50 Mud King XT??
- Trailer Maintenance/Repairs
- 350 chevy flywheel problem...HELP!!!!!
- Disc Brake Dust shields
- Catalytic converters 2-way/3-way
- Need a chuck of bronze tube machined...
- 4.3 Chevy starter????
- I Need A Body Shop!
- good source for gear swap
- beads to balance tires
- HEI Problem
- Tube Bender
Powered by vBulletin™ Version 4.1.1 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.