Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Groups Groups
  • mtnbiker4evr13's Avatar
    09-12-2019, 09:00 AM
    Too bad you can't fit 3.7" bolt circle hubs. I think 70s ford Highboy D44s were 6 bolt 19 spline. I know Herm (overdrive guy) still does FF kits...
    19 replies | 0 view(s)
  • LAR-308's Avatar
    09-09-2019, 12:10 PM
    LAR-308 replied to a thread Frank & Billy engineering in Jeep
    Thanks, I have to regroup and use larger hubs and spindles. I was told about a set of 19 spline hubs that I now know are made of unobtainium. So...
    19 replies | 0 view(s)
  • mtnbiker4evr13's Avatar
    09-09-2019, 10:15 AM
    I don't think I have seen a shaft support bushing in a rear FF setup before but seems like a worthwhile upgrade while its apart. Might be easy to...
    19 replies | 0 view(s)
  • LAR-308's Avatar
    09-03-2019, 09:34 PM
    LAR-308 replied to a thread Frank & Billy engineering in Jeep
    Thanks. The concern with the spindle bearing is supporting the shaft. some hubs have a thorington bearing, while others only have a bushing on the...
    19 replies | 0 view(s)
  • mtnbiker4evr13's Avatar
    09-03-2019, 07:35 PM
    I wouldn't get too excited about a spindle bearing for your FF axle. As a semi float setup the diff takes some of the forces from the axle and the...
    19 replies | 0 view(s)
  • LAR-308's Avatar
    09-01-2019, 02:09 PM
    LAR-308 replied to a thread Frank & Billy engineering in Jeep
    I'm also debating to run a spindle support bearing to support the weight of the axle. Without it the hub will have to support the weight. With the...
    19 replies | 0 view(s)
  • LAR-308's Avatar
    09-01-2019, 02:00 PM
    LAR-308 replied to a thread Frank & Billy engineering in Jeep
    Ok, So one of the things I wanted in this build is to be able to flat tow it. I've been thinking of a full floating kit. Hopefully it be strong...
    19 replies | 0 view(s)
  • ernie's Avatar
    08-25-2019, 09:52 PM
    ernie replied to a thread Frank & Billy engineering in Jeep
    I don't see how the neighbors or the wife could not be proud to have that in your yard!
    19 replies | 0 view(s)
No More Results